Torque wrench for variable torque settings.

Inserts for A/F 46 + 60 available on request.

For hex nuts and threaded connection sleeves.

Compatible with Uni-rod 15 and 20, galvanized.
Loadable according to DIN 18216.

Securely seated with stem and grips.

No risk of accidents caused by slipping off.

Glavanized swivel-joint plate. For use with inclined shuttering. Compatible with Uni 15.

Loadable according to DIN 18216.

Made of free-cutting steel. Compatible with Uni-rods. Not for strength welding!

Loadable according to DIN 18216.

Quality S 355 (St 52-3) on request.
Weldable.


Article 20440210 use only as a locknut.

Reinforced tension jack, galvanized, with spring. For prestressing wire from 5 to 10 mm. Maximum load 10 kN for Ø 10 mm according to DIN 18216.

Forged with tapped thread, galvanized. Compatible with Uni 15.
Loadable according to DIN 18216.

Galvanized. Compatible with Uni 15.
Loadable according to DIN 18216.

Made of free-cutting steel, with stop pin, for extending tie rods. Comaptible with Uni-rods. Not for strength welding!
Loadable according to DIN 18216.
Quality S 355 (St 52-3) on request.
Weldable.

Made of free-cutting steel. Fine-pitch thread for pre-tensioning. Comaptible with Uni-rods.

Observe maximum unscrewed length!

Loadable according to DIN 18216.