B-Greif® for bridge edges
Bracket for locating the BETOMAX® safety rail post on the edges of bridge superstructures.
Properties, benefits:
- Simple installation on the edge of bridge superstructures by pushing on and bracing against projecting reinforcement loop
- Sealing work on the edges of bridge superstructures can be performed without hindrance
- No anchoring in concrete
Safety rail post
Complies with the safety rules for lateral protection and roof safety barriers as a means of safeguarding against falling (GB-I 807 of October 2002). According to DIN EN 12811.
Safety rail post for erecting a temporary side safety system:
- For BETOMAX® GK 2000 ledge consoles
- For sheet piling
- For shuttering supports and timber
- For deck edges and bridge superstructures
- For flights of stairs
- In conjunction with BETOMAX® railing and crash barrier anchors on bridges
Greif® for deck edges
Clamp-type safety rail post bracket for vertical and horizontal component edges.
Clamps to maximum component thickness of 40 cm or 80 cm.
Benefits:
- Quick adjustment by engaging sliding leg
- Spindle sleeve can be tightened without special tools
GS-Test-Certificate Greif for attic (in German)
GS-Test-Certificate Greif for slab edges (in German)
Greif® new
Clamp-type safety rail post bracket. Suitable for timber girders and steel sections.
h = 23 cm
b = 10 cm
Benefits:
- Spindle sleeve can be tightened without special tools
- Quick adjustment by fixed positions for cross bar
- Rotating bearing for the edge board
Krabbe
Bracket for locating the BETOMAX® safety rail post on deck edges. Attached to floor edge shuttering (fixture remains in concrete).
GS-Test-Certificat (in German)
Krabs
Bracket for locating the BETOMAX® safety rail post on deck edges. Attached to formwork at deck edges (fixture remains in concrete).
Concrete cover C:
- Size 1 = 20 mm
- Size 2 = 30 mm
Calculation of tube length:
L = Component thickness - C
GS-Test-Certificate (in German)
Stecker
Bracket for locating the BETOMAX® safety rail post on the edges of concrete floors and bridge superstructures in conjunction with concreted-in Stecker sleeve.
Properties, benefits:
- Simple installation of Stecker sleeve on inside of edge formwork
- Stecker engages in sleeve after striking and before fall protection equipment is installed
- Following work, such as sealing, can proceed unhindered thanks to lateral anchoring
- Cover prevents penetration of concrete during concreting
